Information
Drilling machine with 6 straight machines: GL01/L6; GL01/L8; GL01/L10; GM/L3; GM/L4; KM/C3; KM/L4.
* How assembly axis left:
- Use the type 4: Assembling D1 + D2.
- Use empty 5: Assembling D1 + D2 + D4.
- Use empty category 6: Assembling D1 + D2 + D3.
- Use empty type 7: Assembling D1 + D3 + D4 + D2.
- Use 8 in category: Assembling 2D3 + D1 + D2.
- Use type 10: Installation of 3D3 + D1 + D2.
* Note: When installing axis type 8 or 10 should use 3 wheels (wheel mounted on the D3, in the middle, then the new assembly axis).
2. How to mount wheel axis:
- Installation of long holes large temple square early axis (with chăn hours)
- Installation of boxes at the top of the wheel axis.
- Building approval Xiet sure the temple has long large round holes and building approval at the top axis, action mount 2 wheel axis to the two the same.
3. How fitting drum axis and seeds contain:
- Installation of boxes at the two drums containing the seeds from the first axis (axis of the joint and drums).
- Installation of the load on empty seeds in the same direction.
4. How fitting and pull the hand holds:
* Assembling drag the application:
- Assembling a top bar of iron of 2 to 16 with 2 top 19
- The first steel bar 16 is inserted into the hand grasp
* Assembling pull sometimes category as:
- Installation of 2 trace the letter H in the text between square L 16, 2 the other end of the letter H inserted hand grasp. - The more fit this with 2 axis T, for use as retail space types 5, 7, 9 In.
- If the first U-2 left foot fit with attention, as this fitting T with 4 pillars, used for parity errors in the 6, 8, 10.
Assembling Step:
- Step 1: Installation of 1 wheel on a first axis (except for type 8, 10 are connected to axis 3 wheel).
- Step 2: In turn the drum containing the seeds from the first axis, based on the number of empty want to use as well as the pull to use the T word pivot properly position and full amount.
- Step 3: Installation of the remaining wheel axis as the first step 1 (to make you easily open the lid blank, hand visible in the main wheel mount 2).
- Step 4: Installation of the drag on the drive axis mounted (for easy assembly and no damage to you directly to avoid the need to).
If the drag is to use T 4 pillars, you should assemble 2's arresting image 2 T pillars first, then drag the new mount on the other end of the letter Y.
- Step 5: Check the technical and set up the connector.
You have to have a rice marijuana complete the line to use.
Loading...
